Booting 6855 Series Switches
Console Port
OmniSwitch 6855 Series Hardware Users Guide
September 2011
page 5-3
5
To change the stop bits value, enter
boot serialstopbits
, followed by the number of stop bits. Options
include 1 (default) and 2. For example:
Boot > boot serialstopbits 2
6
Verify your current changes by entering
show
at the boot prompt:
Boot > show
Edit buffer contents:
Serial (console) baud : 19200
Serial (console) parity : even
Serial (console) stopbits : 2
Serial (console) wordsize : 7
(additional table output not shown)
7
You can save your changes to the
boot.params
file by entering
commit file
at the boot prompt:
Boot > commit file
When the
commit file
command is used, changes will not be enabled until after the next switch reboot.
8
You can also save your changes in real time to the switch’s running memory by entering
commit
system
at the boot prompt:
Boot > commit system
Caution.
There are two important things to consider when using the
commit system
command to save
serial connection changes:
•
Output to the terminal may become illegible due to incompatible serial connection settings between the
switch and the terminal emulation software.
•
If you use the
commit system
command only, changes will
not
be saved to the switch’s
boot.params
file and will be lost if the switch is rebooted. To save changes to the
boot.params
file, refer to step 7.
9
Return to the CLI prompt by entering
exit
at the boot prompt.
Содержание OS6855-24
Страница 1: ...Part No 060232 10 Rev G August 2011 OmniSwitch 6855 Series Hardware Users Guide www alcatel lucent com...
Страница 16: ...Technical Support About This Guide page xvi OmniSwitch 6855 Series Hardware Users Guide September 2011...
Страница 136: ...Monitoring the Chassis Booting 6855 Series Switches page 5 8 OmniSwitch 6855 Series Hardware Users Guide September 2011...
