Albrecht GP 1, Инструкция по эксплуатации

Страница: 17 / 38

User Manual Albrecht GP 1
17
6.1.2. GPS only standby page
Die GPS ONLY standby page will appear in the GPS only mode. The display shows
the same compared to 6.1.1. except the channel and CTCSS numbers.
6.1.3. Radio Only standby page
Die RADIO ONLY standby page appears in Radio-only mode (RDO ONLY). There will
be no satellite informations in the display.
•
In the upper field You will find the USER ID (see 6.1.1.)
•
If selected, You see the bar graph for receiver volume (see “Adjusting Volume” in
chapter 9)
•
The operating radio channel number
•
The CTCSS-Subcode- setting.
6.2. LOCATION page
This page shows Your location data, direction (HDG), Speed etc.
•
exact position data (if „NAVIGATION“ appears)
•
Date& Time
•
Direction & Speed (HDG/SPEED)
•
Trip time & Distance
•
Sunrise/Sunset
6.2.1. GPS Satellite STATUS page
The GPS satellite status display shows the relative position, satellite numbers and their
signal strength.
You can enter this STATUS page from the LOCATION PAGE by pressing
ENTER . This
page provides following informations:
•
Satellite positions: Where the satellite is located relative your position.
•
Satellite position graph: The two circles indicates satellite elevation, the outer circle
represents the horizon and the inner circle represents 45 degree from the horizon.
The center of the circle is 90 degree.
•
Satellite signal chart: Displays satellite signal strengths. When the GMR-GPS unit
first tracks a satellite, the strength bar will not be solid until ephemeris is collected. This takes
about 30 seconds .
•
Satellite numbers: identifies the satellite shown on the chart and on the satellite position graph.
User Identity Code
ID CODE
Searching (not ready
Navigation (data can be used)
Satellite Status
Bar graph
GPS receiver signal
strength
CTCSS Subcode
Actual time – depending
on time format
12/24 hrs-display
Operating channel