23
•
If you entered the frequency by mistake, press
●
/Clr
.
•
To enter the frequency anyway, press
E
to accept.
The scanner moves to program mode after you stored the
frequency.
Search Skip Memory
You can skip up to 50 specified frequencies during a search.
This lets you avoid unwanted frequencies or those already
stored in a channel.
Note:
Search skip frequencies are shared by service search,
direct entry search, and chain search. If skip frequencies are
sent in certain mode, the frequencies are also skipped in other
search modes.
•
To skip a frequency, press
Func
and
L/O
when the
scanner stops on the frequency during a search or a
search hold.
•
The scanner stores the frequency in memory and
automatically resumes the search if it is not in hold.
Follow these steps to clear a single frequency from skip
memory so the scanner stops on it during a search.
•
Press
Hold
to stop the search.
•
Press
Func
+
or
Func
+
to select the frequency.
L/O
appears.
•
Press
Func
+
L/O
. The
L/O
icon disappears.
To clear all the skip frequencies at once while searching or
search hold, press
Func
then press and hold
L/O
until the
scanner beeps.
Notes:
•
If you selected all frequenc ies to be skipped within the
search range, the scanner beeps 3 times and does not
search.
•
If you select more than 50 frequencies to skip, each new
frequency replaces a frequency previously stored,
beginning with the first stored frequency.
•
Press
Func
+
or
Func
+
to select a skipped
frequency while
HOLD
appears.
L/O
appears when you
select a skipped frequency.
Delay
Sometimes a user might pause before replying to a
transmission. To avoid missing a reply on a specific channel,
you can program a 2-second delay into any channel or
frequency. The scanner continues to monitor the channel
frequency for an additional 2 seconds after the transmission
stops before resuming scanning or searching. The scanner
automatically sets a delay when you store frequencies into
channels or when you search frequencies. When the delay
feature is on,
DLY
appears. If it is off, follow one of these
steps to program a delay depending on how the scanner is
operating.