20
10 Search Bands Band Plan 2
Frequency Range MHz
Steps
1
25.0000 - 84.0100
5 kHz
2
84.0150 - 87.2550
20 kHz
3 old
108.0000 - 136.9875
12.5 kHz
3 new
108.0000 - 136.9916
8.33 kHz
4
137.0000 - 143.9950
5 kHz
5
144.0000 - 145.9875
12.5 kHz
6
146.0000 - 173.9900
10, 12.5 kHz
7
406.0000 - 449.99375
6.25 kHz
8
450.0000 - 469.9900
10 kHz
9
470.0000 - 512.0000
6.25 kHz
10
806.0000 - 960.0000
12.5 kHz
To switch the band plan between 1 and 2:
•
Make sure the power is turned off.
•
While holding down
0
, turn on the scanner.
Note:
Please carry out a memory initialization (Reset) af ter
band plan was changed. We recommend to change the band
plan setting immediately for the correct country setting before
first use of the scanner, later, in most cases, changing will be
no more necessary.
Chain Search Mode
Press
Func
+
Src
to start chain search mode.
SRCH
, the
enabled search bank number, and or (indicating the search
direction) appear. The search bank number being searched
flashes.
Press
0
-
9
to enable or disable the search bank number being
searched in this mode. Enabled bank numbers appear.
(Disabled bank numbers disappear).
At least one search bank must be enabled. (The scanner
sounds an error tone if you try to disable all the search banks).
The search bank and the frequency where chain search starts
depends on how the scanner was set before you selected
chain search mode.
Chain Search Hold Mode
To start chain search hold mode, press
Hold
in chain search
mode. The scanner stops searching and
HOLD
appears.
•
In this mode, pressing
Func
+
changes the search
direction downward and pressing
Func
+
changes the search direction upward.
•
or
appears according to the current search
direction.
Storing Frequencies Found During Chain Search into
Channel Memory
You can store frequencies you find in chain search mode or
chain search hold mode.
