Search and Scan Function
Search and Scan Function
l
In the Expanded Mode, in order to search for the desired frequencies, Search and Scan functions are provided.
A Dual Watch function is also provided where a specific frequency can be received alternately with a frequency
stored in channel memory.
l
The Search function has three different types.
All Search (
‘
39)
Searches the entire band.
One Touch Search (
‘
39)
Searches between two frequencies written to Search Band Channel Memory.
Program Search (
‘
41)
Searches specific range.
l
The Scan function allows you to access all or specified channel memory addresses in sequence. This function
has three different types.
All Channel Memory Scan (
‘
43)
Scans all the frequencies stored in channel Memorys.
Memory Scan Memory (
‘
44)
Scans specific channel memories .
Block Channel Memory Scan (
‘
45)
Scans frequencies stored in channel memories in a block. A block consists of 100 channel memory addresses.
When a signal is received, Scan/Search stops. There are three ways to stop a Scan/Search and resume the
operation after. This method can be set separately for Scan and Search.
Pause Type
The Scan/Search stops when a signal is received. However, after about 5 seconds, the Scan/Search resumes even
if a signal is being received. This can be changed to a time other than 5 seconds using the Set Mode. (
‘
45).
Busy Type
Scan/Search halts while a signal is being received. If the no signal is received, the Scan/Search resumes after about
2 seconds. To indicate the unit in this Mode, B appears on the display and stays on.
Hold Type
The Scan/Search is held when a signal is received. In order to resume the Scan/Search, turn the Selector or press 5
key or ENT key. To indicate the unit in this Mode, B on the display flashes.
To Change the Search/Scan Type
Hold down FUNC key and press 0/SET key while Scan or Search is activated.
(Illust. 26)
Search the Entire Bandwidth (All Search)
This searches the entire bandwidth.
Set to the FREQ Mode by pressing CLEAR PROGRAM key.
Hold down FUNC key and press 3 SEARCH key. (SEArCH is displayed.)
(Illust. 27-1)
Press ENTkey.
(Search starts immediately.)
(Illust. 27-2)
To end, press CLEAR PROGRAM key.
NOTE:
l
During a search operation, by turning the Selector one click, or holding down FUNC key and press 5/ENT key,
the search is halted and the
„
SEARCH
“
blinks in the display.
l
If the FUNC key is held down and the Selector is turned, the MHz section can be changed without stopping the
search.
