Changing the Frequency to MHz Digit (Fast Step)
In order to change the frequency rapidly, this receiver is equipped with FAST STEP function. This is activated by
turning the rotary selector while FUNC key is pressed. Initially at the factory, a digit of 1MHz is set for this mode
therefore the frequencies change at the digit of 1MHz by activating FAST STEP. The digit of frequency may be
reprogrammed of your preference.
To change the digit of FAST STEP,
Hold down FUNC key and press 0 SET key.
Turn the selector to change the Set menu to display
„
FSt - -u- -
“
.
(Illust. 52)
Hold down FUNC key and turn the selector to set
„
u
“
to be at desired digit.
To complete the setting, press CLEAR PROGRAM key.
Changing the Frequency in 100 MHz Steps
By pressing 5 or ENT key while holding down FUNC key, you are able to change the frequency in 100 MHz steps.
To activate this function
Hold down FUNC key and press 0 SET key.
Turn the selector to change the Set menu to display
„
OFF ud100
“
.
(Illust. 53-1)
Hold down FUNC key and turn the selector to change display from
„
OFF
“
to
„
on
“
.
(Illust. 53-2)
To complete the setting, press CLEAR PROGRAM key.
REFERENCES
Troubleshooting
In case of malfunction, check if any of the following items may be causing the problem before you determine the unit
is defective and require servicing.
SYMPTOMS
CAUSE
The power cannot be turned on.
The battery may be fully exhausted.
The frequency cannot be changed.
The Key Lock may be activated.
Not receiving any signals or only strong
The antenna is not properly connected.
signals are received.
The radio station is too far away.
The squelch knob is turned fully clockwise.
A large value is set in RF Squelch setting.
No audio
The volume knob is turned fully counterclockwise.
RF Squelch is set.
The reception Mode does not match.
Receiving Sound is Distorted.
The reception Mode does not match.
Noise is emitted.
The squelch knob is turned fully counterclockwise.
( Squelch is off)
