Albixon ELEGANCE 70, Руководство пользователя

Страница: 21 / 84

1.
Placing the device 3
2.
Mounting the swim jet body 3
3.
Installing the swim jet body 5
4.
Air and pneumatic line installation 6
5.
Fitting the swim jet front cover 7
6.
Minimum space requirements and device installation 8
7.
Use and settings of the ELEGANCE swim jet 9
8.
List of ELEGANCE swim jet components 10
9.
Electrical installation 11
10.
ELEGANCE swim jet pump 12
11.
Warranty conditions 13
12.
Photo documentatiton 14
Contents
Thank you for choosing our product and trusting our company. To help you to get the maximum
pleasure from using this product, please read these instructions carefully before use and strictly follow
the user´s manual to prevent damage to the device or unnecessary injuries.
2
/ Swim jet ELEGANCE 70
Placing the device
By purchasing the ELEGANCE swim jet device, you have obtained a high-quality product that will help
you to enjoy the time spent in your pool.
The electric pump should be installed as close as possible to the pool in order to achieve the maximum
performance and to reduce loss caused by friction. The original diameters of the accessories from PVC
delivered with the installation should always be respected.
Pump which is a part of this device don’t have a self-suction function. It is necessary to install it under the
water level. The technology device area must be aired sufficiently, use a fan if needed, to prevent water
condensation. You can ensure the correct functioning of the device by respecting these instructions.
Mounting the jet stream body
During the installation of the swim jet body, please bear in mind that it must be placed in the position
indicated in picture 1. Displacement of a 75mm diameter and a suction of a 90mm diameter must
be installed in the vertical position so that the side of the displacement is higher than the side of the
suction (90 mm diameter) (see pic. 1). The swim jet device must be placed so that the centre of the jet
will be approximately 250 mm under the surface of the water (see pic. 1). The start of the cut out for
the swim jet plastic body should be 180 mm from the future water level. At this height the center of
the nozzle will be 250 mm below the surface. You must follow and adhere to these instructions and
correctly mount the device to ensure that it operates correctly.
1.
2.
WATER LEVEL
DISPLACEMENT
INTAKE
CORRECT INCORRECT INCORRECT
PIC. 1
250
mm
180
mm
Swim jet ELEGANCE 70 /
3
ELEGANCE 70 / 80 / 95 |
19