20
Manuale Uso MP NIWA - Code 10011873 - Edition 1 - 03/2008
Instructions for operation
English
Whirlpool nozzles
The whirlpool nozzles are positioned specially to
provide a benefi cial hydromassage that begins
at the extremities and moves towards the centre
of the body.
Certain of the jets can be oriented in any direction
simply by rotating the nozzle.
The intensity of the jet can be adjusted by rotating
the external ring. Turn the ring in one direction or the
other to increase or decrease the quantity of water
and air delivered so that you can enjoy a delicate
or vigorous massage.
Turn the ring completely clockwise to shut off
the jet.
Airpool valves
The valves positioned on the bottom of the tub,
which inject jets of air, make up the Airpool system.
When the system is in operation, you can enjoy a
thermal geyser eff ect which gently and gradually
massages the entire body and relieves muscular
tensions, adding the ozone function if desired.
Turbopool system
The original TURBOPOOL system features both the
WHIRLPOOL and AIRPOOL systems. When used
simultaneously, these provide a treatment which is
especially eff ective, an extraordinary massage that
envelops the entire body.
1
2
3
IMPORTANT:
Carefully read all the instructions for the use
and conservation of the chemicals, and be sure
to follow the manufacturer’s instructions shown
on the container.
After adding the chemicals, the fi ltration system
should be operated for about 30 minutes to ensure
that they are completely dissolved in the water.
Never clean the fi lters or the fi lter cartridges
when the pump is in operation.
Switch off the appliance using the main
switches.
Always fi ll the Mini-pool to the mark shown on
the skimmer (refer to the paragraph “Operating
the appliance for the fi rst time”). Never start the
pump or the heater if the level of the water is not
above the hydromassage nozzles.
Always turn off the appliance using the main
switches when the Mini-pool is empty.
The Mini-pool is not fi tted with an overfl ow
outlet. When fi lling the tub, take into account
the number of persons using the Mini-pool and
their build.
The users should get into the Mini-pool one at a
time, ensuring that the water does not overfl ow
from the upper edge. If necessary drain off some
of the water.
Preparing for use
Attention:
The preliminary checks and any system
adjustments must be performed by qualifi ed
authorised personnel, under their own
responsibility.
The instructions may be found in the Installation
Manual.
The user must appoint a qualifi ed person able
to manage and run the system, in particular as
regards the following operations:
• Filling the Mini-pool with water.
The optimum level is obtained when the water
reaches the level mark on the skimmer.
A normal garden hose may be used to fi ll the
Mini-pool.
• Verifi cation of water quality, chemical control
of pH and water sanitation.
These checks must be performed frequently to
guarantee long-term water quality, especially if
the
Mini-pool
is used by several persons.
• Make sure that ALL the operations described
in the section
“ Operating instructions - General
Warnings - Initial Start- up” have been carried
out.
• Switch on the system master switches which are
located in a safe area accessible to the user.
Attention:
Do not power the system if the Mini-pool is not
fi lled with water up to the normal fi lling level,
as this may damage the pumps.
Failure to observe this warning will immediately
invalidate the warranty.
