KM400T-8X Series
34
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system board.
You will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)
、
Disabled
UBS 2.0 Driving
This item allows you to control the transmission single to drive the USB 2.0 devices.
nables support for USB attached devices. Options: Disabled (default)
、
Enabled
)
、
Disabled
the first serial port.
、
Auto
the second serial port.
ptions: Disabled
2F8/IRQ3 (default)
、
3F8/IRQ4
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto.
arallel port interrupt and address.
、
278/IRQ5
、
3BC/IRQ7
、
Disabled
Options: The range is 00-FF, and the default is 11.
USB Device Support
E
Super IO Device
If you highlight the literal “Press Enter” next to the “Super IO Device” label and then press the enter
key, it will take you a submenu with the following options:
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select “Disabled”
in this field. Options: Enabled (default
Onboard Serial Port 1
Select an address and corresponding interrupt for
Options: Disabled
、
3F8/IRQ4 (default)
、
2F8/IRQ3
、
3E8/IRQ4
、
2E8/IRQ3
Onboard Serial Port 2
Select an address and corresponding interrupt for
O
、
Onboard Parallel Port
This item allows you to determine the p
Options: 378/IRQ7 (default)
