Albatron K8Ultra-U Series, Руководство пользователя

Страница: 33 / 47

K8Ultra-U Series
29
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on
your system. This field is only configurable when “Power On Function” is set to “Hot Key”.
Options: Ctrl-F1
、
Ctrl-F2……Ctrl-F12
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install an add-in FDC or the system has no floppy drive,
select “Disabled” in this field. Options: Enabled (default)
、
Disabled
Onboard Serial Port 1
Select an address and corresponding interrupt for the first serial port.
Options: Disabled
、
3F8/IRQ4 (default)
、
2F8/IRQ3
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto
Onboard Serial Port 2
Select an address and corresponding interrupt for the second serial port.
Options: Disabled
、
2F8/IRQ3 (default)
、
3F8/IRQ4
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto.
UART Mode Select
This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)
、
ASKIR
、
IrDA
RxD,TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if “UART
Mode” is set to “ASKIR” or “IrDA”. Options: Hi/Lo (default)
、
Hi/Hi
、
Lo/Hi
、
Lo/Lo
IR Transmission Delay
This item allows you to enable/ disable IR transmission delay. This field only configurable
if “UART Mode” is set to “ASKIR” or “IrDA”. Options: Enabled (default)
、
Disabled
UR2 Duplex Mode
Select the transmission mode used by the IR interface. Full-duplex mode permits
simultaneous bi-directional transmission. Half-duplex mode permits transmission in only
one direction at a time. This field only configurable if “ UART Mode” is set to “ASKIR” or
“IrDA”. Options: Half (default)
、
Full
Use IR Pins
Consult your IR peripheral documentation to select the correct setting of the TxD and
RxD signals. This field is only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
Options : IR-Rx2Tx2 (Enabled)
、
RxD2, TxD2
Onboard Parallel Port
This item allows you to determine the parallel port interrupt and address.
Options: 378/IRQ7 (default)
、
278/IRQ5
、
3BC/IRQ7
、
Disabled