Albalá Ingenieros FRS3004C02, Руководство пользователя

Страница: 12 / 32

Albalá Ingenieros | Manual FRS3004C02
• The FRS3004C02 module and the mounting frame should always be
installed, maintained, operated and removed by personnel with sufficient
technical qualifications. The equipment should never be placed in damp
areas, near splashing liquid, or in explosive or corrosive atmospheres.
Neither modules nor mounting frames can be used in applications that
could endanger human life.
3.3. Environmental considerations
This symbol indicates that this equipment must be deposited at a collection
point for proper waste treatment once it has reached the end of its useful
life.
3.4. Power considerations
The UR3000 and UR3100 mounting frames can house as many FRS3004C02 modules as
will fit in them.
3.5. Module configuration
The FRS3004C02 contains microswitches that should be configured before installing the
module into mounting frame. This configuration can be modified using the control
software, however upon startup the values set by the microswitches take precedence.
Switch S1 configures the operating mode of the module as shown in the following table.
S1 OFF ON
1
REF DGTL ANLG
2 FAIL BLK FRZ
3 SYNC LIN FRM
- REF: Specifies which type of reference signal the module will use: analog (ON-ANLG)
or digital (OFF-DGTL).
- FAIL: Specifies the behavior of the outputs in case of errors in the input signal: frozen
screen (ON-FRZ) or fade to black (OFF-BLK).
- SYNC: Specifies the wait time after an error has been detected in the input signal, the
error has been cleared and before considering that signal to be valid once again and
storing it to memory: the signal must be valid for at least one frame (ON-FRM) or the
signal must be valid for at least one line (OFF-LIN).
The modules come from the factory with the following settings: analog reference, frozen
image response to errors, frame synchronization.
12