Albalá Ingenieros, S.A. HVD3001C04, Руководство пользователя

Страница: 15 / 30

Albalá Ingenieros | Manual HVD3001C04
3.5. Installation of SFP/SFP+ modules
The HVD3001C04 features receptacles to install optional SFP/SFP+ modules for signal
transmission or reception over optical fiber or other functions. To install or uninstall one
of these modules in the equipment, follow the instructions given below.
To install, insert the SFP/SFP+ module into the receptacle and slide it carefully until it
clicks, indicating that the module has reached its final position.
The HVD3001C04 features receptacles to install optional SFP+ modules for Ethernet
signal transmission or reception that are sold separately. To install or uninstall one of
these modules in the equipment, follow the instructions given below.
To uninstall, first remove any optical or electrical cables that are connected to the
SFP/SFP+ module. Then lift the metal ring located at the opening of the SFP/SFP+
module to disable the module's retention mechanism and release it. Finally, pull module
carefully out of its receptacle.
There are different types of SFP/SFP+ modules. Make sure that module to be installed is
appropriate for the receptacle that will contain it.
3.6. Installing the module in the mounting frame
The steps needed to install the HVD3001C04 module with the rear board in the
mounting frame are:
1 - Disconnect all power cords from the power supplies of the mounting frame.
2 - Remove the blank panels covering the front and rear of the empty bays chosen for
installing the HVD3001C04 in the mounting frame.
3 - Install the XVD3000P10 rear board ensuring that its 12-pin connectors are properly
aligned with the mounting frame´s mating connectors. Check that the orientation of
the board is correct by looking at the placement of the text printed on it according to
the illustration below.
4 - Attach the rear board to the mounting frame with two M3 metric screws and tighten.
5 - Insert the HVD3001P02 board (main board of the HVD3001C04 module) into the front
of the mounting frame. The edges of the card slide into two plastic guides inside the
mounting frame.
6 - Conector the two fiber optic LC connector pigtails coming from the rear board to the
SFP modules.
7 - Affix the main board to the mounting frame using the two screws included on the
front panel.
After these steps, the module is ready to be connected to other equipment.
15