17
3.2 Overview of initial setup operations
This section provides an overview of the operations required when you first install the Device.
For detailed operations, see the subsequent sections.
NOTE
The operations below are the minimum requirements for initial installation.
For details about the operations after the initial operations, see the manuals
listed in
4.1 operation management and configuration settings
.
(1) Login
Log in to the Device. Use the user name
operator
, which was set at the initial installation (you can log
in without authentication because a password is not set for
operator
).
(2) Setting the administrator mode password
Use the
enable
command to specify a password for entering administrator mode. At the initial
installation, this password has not been set. To ensure security, set a password for administrator mode.
(3) Adding a user account and deleting the user account
operator
Create a new user account.
If you do not intend to use the login user
operator
, which was set at the initial installation, we
recommend that you delete it by using the
no
username
command after creating a new login user. Doing
so strengthens security.
(4) Setting the time
Set the time zone and the time. At the initial installation, the exact time has not been set. Because the time
is important information that is used to collect failure information, set the exact time.
