5． Measurements
5-1 Real time measurement
1. Turn on Power SW
①
and confirm an indication of LCD.
Display of a measuring mode
｢
H
｣
Broad Leaf Tree
and
｢
LLL
｣
z
Turning on Power while inserting the probe to the object indicates
｢
LLL
｣
once on the display and then
displays a measuring value in 2 to 3 seconds.
2. Select a mode suitable for the measuring object by pressing a Mode Change key
｢
G
｣
③
.
(refer to 4-3 changes of measuring modes page at 5)
3. Wait for reading the display until the display has become stable by inserting Electrode into the measuring
object.
4. Press a Hold
･
Average key
②
to display
｢
0.0 %
｣
with a sound of “Peep”.
When probing an object, it emits “peep, peep” sounds and when releasing it,
a “ peep” sound again with a measured valued indicated on LCD
⑦
.
＊
Do not probe other object until the above sounds of 3 times has finished
otherwise that may cause measurement errors.
An indicated value does not change when a measured value indicates not
more than the measurement range.
When a measured value indicates not less than the measurement range,
｢
HHH
｣
blinks with sounds of “ peep, peep, peep”.
Releasing a probe displays
「
0.0%
」
.
5. Press a Hold
・
Average key
②
again for releasing the Hold state.
Note) When stubbing a probe into a measuring object:
Keep Hold Mode released until stubbing has been completed. Make sure of changing to Hold Mode to
read a measured value after finishing the stubbing.
(Stubbing during a Hold mode in process may cause measurement errors because it displays data while
in process of stubbing.)
Office: Jl. Radin Inten II No. 62 Duren Sawit, Jakarta 13440 - Indonesia
Workshop: Jl. Pahlawan Revolusi No. 22B, Jakarta 13430 - Indonesia
Phone: 021-8690 6777 (Hunting)
Fax: 021-8690 6777
Mobile: +62 816 1740 8925
