4-4 Changes of Hold Mode
A press of Hold
･
Average Key
②
turns to the Hold Mode with a
「
peep
」
sound.
Each press of the key changes the Hold Mode alternately to ON or OFF and
「
Hold
」
is displayed on LC Display
⑦
when ON is in process. The displayed
measuring value is on hold until a next measuring value has been input.
＊
A press of long periods (approx. 1 sec.) turns to Average Value Mode
(temporal memory).
To release it, press again and hold the Hold
・
Average Key
②
for long periods (approx. 2 sec.).
4-5
Setting of Upper Limit Values
・
Press the Upper Limit Value Key
「
H
」⑥
when Power ON is in process.
・
A buzzer emits
「
peep
」
sounds and the
「
H
」
,
「●」
marks of an upper limit
value indications and
「
50.0%
」
of the range of the upper limit are displayed.
・
Press and hold a
「▼」
key
④
until it has reached to a desired upper limit value.
Keeping the
「▼」
key
④
pressed changes to a fast winding of numerical values.
・
Release your finger of the
「▼」
key
④
when the values has reached to a
desired value.
・
When the value has reached too small beyond the desired one, press the
「▲」
Key
④
to adjust the value
．
・
Set an upper limit value by pressing the
「
H
」⑥
key again. ex) set upper limit value to 20%
・
A buzzer emits a “ Peep” sound and the upper limit setting mark
「●」
is
indicated on the edge of the left side of LCD display
⑦
.
＊
An interval between setting values is a 0.5% notch.
＊
“ TEMP”, “HOLD” is not displayed during in process of setting.
＊
Possible to activate the same operations even at the MC mode.
Office: Jl. Radin Inten II No. 62 Duren Sawit, Jakarta 13440 - Indonesia
Workshop: Jl. Pahlawan Revolusi No. 22B, Jakarta 13430 - Indonesia
Phone: 021-8690 6777 (Hunting)
Fax: 021-8690 6777
Mobile: +62 816 1740 8925
