・
At a real time measuring, it sounds a buzzer “ Peep, Peep, Peep “ when a measuring value exceeds a setting
value, and the upper limit value and the measuring value alternately blinks on the display while being probed to
contact. Releasing the probe turns to
「
LLL
」
on display.
・
At a Hold Mode measuring, when it exceeds the setting value and even after releasing the probe off the object,
the upper limit value and the measured value are alternately kept blinking.
・
Press a
「
H
」
key
⑥
again and repeat the same procedures as before to change upper limit values.
Possible to operate the same procedures during measuring in process (Hold mode or Non-Hold mode).
＊
When Upper Limit Value is unnecessary for an initial operation, press again the
｢
H
｣
key after pressing first
the
｢
H
｣
key. In this case the Upper Limit Value is set at 50%, Maximum.
＊
To delete an Upper Limit Value, set the Upper Limit Value at 50 % or switch Power to OFF.
And the Upper Limit Value will also be deleted when Power switches OFF with Auto-Power-Off.
4-6 Changes of Key -Lock Mode
A press of a Lock Key
⑤
locks all the keys except Power SW
①
and
prevents erroneous operations. Switch off Power to release.
Office: Jl. Radin Inten II No. 62 Duren Sawit, Jakarta 13440 - Indonesia
Workshop: Jl. Pahlawan Revolusi No. 22B, Jakarta 13430 - Indonesia
Phone: 021-8690 6777 (Hunting)
Fax: 021-8690 6777
Mobile: +62 816 1740 8925
