11
Quick Start
First Time Start Up
1. Unpack the lock.
2. With the batteries disconnected, hold down the
;
key for 10 seconds and release.
3. Connect the batteries and listen for 3 beeps. Within 5 seconds of hearing the 3 beeps, press and hold
;
until beeping
starts. This will clear the lock of all programmed data. Important: If you do not hear these 3 beeps, you must start over at
step 2.
4. Listen for another series of beeps and LED flashes
followed by 10 seconds of silence
. The lock is now ready to program.
Failure to follow this exact procedure can result in erratic lock behavior.
Important Note:
When entering any key se-
quence below,
do not pause more than 25 seconds between any key presses
--otherwise you must start again.
Enter Program Mode and Change Factory Master Code
1. Press the default Master Code:
1
2
3
4
5
6
.
2. Wait for the green light and press
;
until multiple beeps are heard. You are now in Program Mode.
Note:
The lock will beep every 6 seconds as a reminder that you are in Program Mode.
3. Enter a new personal 6-digit Master Code number by pressing the following keys:
;
1
;
[
new Master Code
]
;
[
new Master Code
]
:
(the second set of digits must be exactly the same).
(For example, if you want your new Master Code to be "664433". Press:
;
1
;
664433
;
664433
:
).
Now that the Master Code has been changed, there is no need to change it again (unless you want to). Since you are
still in Program Mode, you can now proceed directly below and program various functions.
Note:
Programming any
Function, such as setting the clock, follows a consistent 5-step pattern: (1) Enter Program Mode (2) Press
;
[Function #] (3) Press
;
and enter data (4) Press
:
to end (5) Exit Program Mode.
Note:
There is a 3 minute Program Mode timeout if no keys are pressed when in Program Mode. A steady tone will sound
for the final 15 seconds of the 3 minute timeout period as a warning. To remain in Program Mode, press any key.
Set the Weekday
1. Enter Program Mode (if not in already).
2. Press
;
40
;
[
number of weekday
]
:
. (Use 1= Sunday, 7 = Saturday).
(For example - Friday - press
;
40
;
6
:
).
Set the Date
1. Enter Program Mode (if not in already).
2. Press
;
38
;
[
MMDDYY
]
:
.
(For example - May 10, 2002 - press
;
38
;
051002
:
).
Set the Time
1. Enter Program Mode (if not in already. If you just finished the above procedure, you are still in Program Mode).
2. Press
;
39
;
[
HHMM
]
:
. (Use 24-hour military format, where PM adds 12 hours).
(For example - 2:30pm - press
;
39
;
1430
:
).
Enter User Codes
1. Enter Program Mode (if not in already).
2. Press
;
2
;
[
User Number
]
;
[
new User Code
]
:
.
