Alarko SUPER FIT 24, Инструкции по сборке, установке и эксплуатации

Страница: 36 / 56

36
Figure 14. Minimum installation
clearances
Figure 15. Mounting Instructions
4.4 Installation of the Boiler
■ The appliance must be installed
exclusively on a flat vertical solid
wall capable of supporting its
weight.
■ The boiler should be fitted within
the building unless protected by
a suitable enclosure in an open
area such as garage, balcony.
In this manner, the boiler can be
fitted inside a cupboard. Contact
Alarko Carrier for proper cupboard
dimensions.
■ If the boiler is sited in an unheated
enclosure then it is recommended
to leave the power on to give frost
protection. Frost protection is
active even if the appliance is in
OFF position.
If the boiler is installed in a room
containing a bath or shower, reference
must be made to the national standards
and local requirements. In order to
allow access to the interior of the
boiler for maintenance purposes,
it is important that the necessary
clearances indicated in Figure 14 are
respected. For mounting the appliance,
it is required to follow the below
instructions (Figure 15). Determine the
right position for the boiler with respect
to the required clearances for servicing
and the position of the flue. Firstly, mark
the fitting points on the wall by means of
mounting template located in packaging
box and a spirit level (Figure 15 – Step
1). Mount the L screws together with
wall plugs from the marked points.
Finally, hang the boiler from L screws
(Figure 15 – Step 2).
Opening the Package
4.4 Installation of the Boiler
Figure 23. Opening the package
■
Figure 25. Mounting Instructions
4.4 Installation of the Boiler
■ The appliance must be
installed exclusively on a flat
vertical solid wall capable of
supporting its weight.
■ The boiler should be fitted
within the building unless
protected by a suitable
enclosure in an open area
such as garage, balcony. In
this manner, the boiler can
be fitted inside a cupboard.
Contact Alarko Carrier for
proper cupboard
dimensions.
■ If the boiler is sited in an
unheated enclosure then it
is recommended to leave
the power on to give frost
protection. Frost protection
is active even if the
appliance is in OFF position.
■ If the boiler is installed in a room
containing a bath or shower, reference
must be made to the national standards
and local requirements. In order to
allow access to the interior of the boiler
for maintenance purposes, it is
important that the necessary
clearances indicated in Figure 24 are
respected. For mounting the appliance,
it is required to follow the below
instructions (Figure 25). Determine the
right position for the boiler with respect
to the required clearances for servicing
and the position of the flue. Firstly, mark
the fitting points on the wall by means
of mounting template located in
packaging box and a spirit level (Figure
25 – Step 1). Mount the L screws
together with wall plugs from the
marked points. Finally, hang the boiler
from L screws (Figure 25 – Step 2).
Figure 24. Minimum installation clearances
Figure 25. Mounting Instructions
No Part name Pieces
1 Template 1
2 Wall plug 2
3 L screw 2
Note
-
To be used as guide.