Alamo John Deere 6215, Руководство по сборке и инструкция

Страница: 53 / 128

© 2004
Alamo Group Inc.
Section 5 - 3
Machete (JD -62,63,6420 Asy Man) 10/04
Tractor Stack Valve Modifications S/N 398796 & Down
Tractor Stack Valve
Modification:
1.
Clean the Are around Stack Valve on rear
of Tractor. The area around the Stack Valve on
Tractor must be cleaned of all dirt before any
work is performed; NO DIRT or any contamina-
tion can be allowed to get in Hydraulic System at
all. If Hydraulic System is contaminated it will be
damaged.
2.
Clamping Stack Valve to Prevent Move-
ment of Valve Components. This is very critical,
do not loosen or remove any Bolts or Nuts till this
has been done, Stack Valve must stay clamped
together the complete time this replacement is
being done!
(See Figure 2)
3.
Un-Bolt Original LH End Plate. There are
3 Nuts on the left end Plate of Stack Valve,
remove these 3 nuts. These Nuts are sunk into
a machined recess and will require a tool that will
fit into the recess.
(See Figure 3)
4.
Remove Original LH End Plate. Pull the
original LH End Plate off (See Figure 4), Check
to make sure that all the O-Rings came off with
the End plate. If not take the O-Rings off of Stack
Valve.
5.
Inspect Stack Valve End Plate Area.
Area must be clean. (See Figure 5)
Figure 5
Figure 4
Figure 2
Figure 3