Alamo John Deere 6215, Руководство по сборке и инструкция

Страница: 104 / 128

Machete (JD-62, 63, 6420 Asy Man) 10/04
© 2004
Alamo Group Inc.
Section 9 - 2
1.
Hoses on Booms are shipped folded
back inside Boom. Hoses must be pulled out
and moved to clear, then routed in the end of
Boom before installing Boom on the King Post
(See Figure 1)
2.
Pull the Lift Cylinder out to its full stroke,
to aid in the installation of the Lift arm (See
Figure 1). When Pulling Cylinder Out, attach a
Hose to the Rod end and lay the Hose in a drain
pan. This will catch any Oil expelled when Cyl-
inder is pulled out.
3
. With a hoist raise the Boom Arm (1)
and lower onto the King Post (2). Align the
Boom Arm and King Post with the Lift Hinge
Point. Insert Main Pin Bolt (3) into Boom
Weldment and Turning Arm. Attach
Lockwasher (4), Washer (5) and Bolt (6) and
tighten (also see Parts Section on the Boom
Assembly)
(See Figure 2)
4.
Attach the Rod end of the Lift Cylinder
(7) to the Lift Section with Pin (8), Bolt (9) and
Nut (10) (also see Parts Section on the Boom
Assembly)
(See Figure 3).
Boom Installation 2 WD & 4 WD
Boom Installation / Boom Hoses:
Orange
Red
Blue
Yellow
Yellow
White
Figure 2
Head End Boom,
Hose Colors
Figure 1
Hoses
Boom
Note: Additional support may
be need at the end of the Boom
to aid in installation.
Approximate Lift pont
1
3,4,5,6
8,9,10
7
2
Figure 3