Alamo John Deere 6215, Руководство по сборке и инструкция

Страница: 18 / 128

Machete (JD -62,63,6420 Asy Man) 10/04
© 2004
Alamo Group Inc.
Section 3 - 4
Pump / Drive Assembly Instructions
Installing Pump Drive Components:
(continued)
4B.
Remove Factory Pulley
NEW STYLE model & S/N
JD-6415 S/N 6415M355436 & up
JD-6320 S/N 6320H361093 & up
JD-6420 S/N 6420H354700 & up
( New Style 5 Spoke Cast Pulley See Figure 4).
This Pulley must be replaced, as it will not work
when mounting a Machete because the Driveshaft
cannot be connected to it. Remove the center
retaining Bolt that screws into Crankshaft. Using a
long extension through the Crankshaft Access
Hole in the front of tractor (See Figure 2) easily does
this. The Pulley Retaining Bolt and Shouldered
Washer will need to be removed, The Pulley and
Shouldered Washer will not be reused (See Figure
4), the Retaining Bolt is the only thing you will reuse.
Install Replacement Crankshaft Pulley, All
paint must be removed from ID of new pulley. Clean
nose of crankshaft pulley using LOCKTITE 7649
(TY16285) clean and cure primer. Note: Do Not
over apply retaining compound. Use only a thin coat
of retaining compound to avoid difficulty in removal
of vibration damper. Apply a light 2mm - 3mm (.079
- .118 in.) bead of Locktite 680 (TY15968) retaining
compound (maximum Strength) (C) around the
leading edge of the crankshaft nose.
(See Figure
7A)
Use a new Retaining Bolt (See Figure 4)
and the New washer (P/N 02979829) , the Bolt
must be SAE Grade 8 or better
(See Figure 4, 5 &
7) install the Replacement Pulley (P/N 02979857)
(See Figure 5 & 6). Dip the Retaining bolt in clean
SAE 30 engine oil. Make certain the Washer is fit
inside center hole of replacement Pulley
(See
Figure 7) . Tighten original Pulley retaining Bolt to
Tractor Engine now as you will not be able to after
you install the Driveshaft Pulley Adapter. Tighten
Crankshaft Pulley retaining bolt to John Deere
Specifications.
The required torque specifica-
tions for the pulley retaining bolt (See Figure
4) is 369 ft. lbs (500 nm) Note this only applies
to the tapered crankshaft pulley assembly.
Figure 6
Engine Side of
Pulley
Driveshaft
Side of Pulley
Replacement
Pulley Part
#02979857
Replacement
Washer Part
#02979829
Replacement
Pulley Part
#02979857
Figure 5
Figure 4
Factory 5
Spoke Cast
Pulley
Factory
Pulley
Retaining Bolt
Factory
Shouldered
Washer
Clean all Paint
from ID of
Pulley