AL-KO Solo Robolinho 110, Инструкция по эксплуатации

Страница: 61 / 376

457290_b 61
Transport
6. Push in new cutting blades with the sharp-
ened side pointing towards the appliance.
Note: It is only allowed to use original spare
parts from AL-KO.
7. Insert the fastening screws again and firmly
tighten.
As a rule, the clearer blades do not need to be
replaced.
In case of stubborn dirt that cannot be removed
with a brush, the blade plate must be replaced
because an imbalance can lead to increased
noise levels, greater wear and malfunctions.
9.4 Replacing the fuse on the
transformer (11)
If the transformer no longer provides any current
although the mains voltage supply is intact:
1. Disconnect the transformer (11/2) from the
mains supply.
2. Unscrew the fuse cover (11/1) including the
fuse from the transformer (11/2).
3. Check the fuse. If defective, insert a new fuse
with the same rating (2.5 A, slow blow).
4. Insert the new fuse in the fuse cover.
5. Screw in the fuse cover including the fuse in-
to the transformer.
10 TRANSPORT
For transporting the appliance, e.g. from the main
area to the secondary area, proceed as follows:
1. Stopping the appliance.
2. Switching off the appliance.
3. Lift the appliance by the carrying handle:
■
Do not touch the cutting blades.
■
The cutting blades must always point
away from the body.
11 STORAGE
11.1 Storing the automatic lawn mower
The appliance must be stored over winter or
when it is to be taken out of service for an ex-
pected duration of longer than 30 days.
1. Fully charge the rechargeable battery (see
chapter 5.1 "Charging the rechargeable bat-
tery (09)", page 54
).
2. Thoroughly clean the appliance (see chapter
9.1 "Cleaning", page 59 ).
3. Store the appliance:
■
upright on all wheels
■
at a dry, lockable location protected from
frost
■
out of the reach of children
11.2 Storing the base station
The base station can, but does not have to be put
into storage. However, the storage prevents pre-
mature ageing, such as fading of the colour, cor-
rosion of the charging contacts and the spring
force terminals.
If the base station remains outdoors:
1. Remove the low-voltage cable from the trans-
former and roll together.
2. Put the transformer into storage.
3. Grease the charging contacts with contact
grease.
When the base station is to be put into
storage:
1. First, carry out all work mentioned above.
2. Disconnect the base station from the bound-
ary cable.
3. Remove the base station and remove any
soiling with a broom and a slightly damp
cloth.
4. Store the base station:
■
at a dry, lockable location protected from
frost
■
out of the reach of children
11.3 Winter storage of the boundary cable
The boundary cable can remain in the ground
and does not need to be removed.
1. When the base station has been put into stor-
age: Grease the stripped cable ends with
contact grease and wrap with adhesive tape.
This protects the cable ends against corro-
sion.