AL-KO Robolinho 1150, Руководство пользователя

Страница: 78 / 652

78 Robolinho
GB
Help in case of malfunction
13.2 Fault codes and troubleshooting
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Help in case of malfunction
Remedy
Check the LEDs on the base station.
Check the power source of the base
station. Disconnect and reconnect
the power supply.
Check the boundary cable for
damage. Repair the defective cable.
Check the LEDs on the base station.
Malfunction Cause Remedy
Rechargeable battery
operating time is
significantly shorter. Cutting height level is too
low. Increase the cutting height, then lower
in stages to the required height.
Grass is too long or too wet.
■
Let the grass dry.
■
Set the cutting height to a higher
level.
Appliance vibrates or the
volume is too high. Imbalance on the cutting
blade or in the cutting blade
drive
■
Clean the mower deck.
■
Contact an AL-KO service centre.
Rechargeable battery
cannot be charged or low
battery voltage
■
The charging contacts of
the base station are
dirty.
■
The contact surfaces on
the appliance are soiled.
Clean the charging contacts and contact
surfaces.
Base station has no power. Connect the base station to the power
source.
The appliance does not
touch the charging contacts.
■
Place the appliance in the base
station and check that the charging
contacts make contact.
■
Contact an AL-KO service centre.
The service life of the
rechargeable battery has
expired. Contact an AL-KO service centre.
The charging electronics are
faulty. Contact an AL-KO service centre.
Fault code Cause Remedy
CN001: Tilt sens or The inclination sensor has
been triggered:
■
Max. tilt exceeded
■
The appliance has been
carried
■
Slope too steep
Place the appliance on a flat surface
and acknowledge fault.
CN002: Lift sens or The lift sensor has triggered:
■
The appliance cover has
been deflected upwards
by lifting or by an
obstacle.
Remove the obstacle.
CN005: Bumper de-
The appliance has driven
into an obstacle and cannot
free itself (e.g. collision close
to the base station).
■
Place the appliance on the free,
designated grass surface.
■
Correct the location of the boundary
cable.
flected