9
Remove the protective paper from the double-sided tape.
Carefully move the aquariums into position. Remember
to work from your layout plan.
NB. If a pipe system is mounted, all aquariums in the
same section must be of the same type.
Clean the plastic sheets carefully and mount them on the
rear of all aquariums.
Position a white pad under
each corner of all aquari-
ums.
The white pad must be
flush with the outside
edges of the aquarium. Pull
the aquariums forward all
the way to the front edge of
the shelving unit.
The rubber gasket and cap
will sit inside the aquari-
um.
If no pipe system is mount-
ed, seal the holes with the
plugs.
There may be 2 gaskets on
certain bushings. These are
for adjustment purposes
and must be left in posi-
tion.
Remove the nut and the
white washer from the
return pipes.
Carefully guide the return pipes behind the shelving unit.
Mount the white washers
and screw the nuts onto the
bushings.
Push the bushings up
through the holes in the
base glass of the aquari-
ums.
