
12
13. MODIFIED COEFFICIENT TABLE OF AMBIENT CONDITION POWER
The conditions of generator rated output:
Altitude:0m Ambient temperature: 25 Relative humidity: 30%
The conditions of generator rated output:
Altitude: 0 m Ambient temperature: 25 Relative hu-
midity: 30%
14. STORAGE
14.1. Engine
- If the engine is to be put out of service for a long pe-
riod of time, it is necessary to drain out lubricating oil,
cooling water and fuel when engine is still warm after
stopping the engine
- Perform maintenance accordingly.
- Dismount intake and exhaust manifolds and pour
into the cylinder liner the from the air passages about
0,2 kg of clean dehydrated oil (By heating the lubricat-
ing oil I 10 - I20°C, until all air bubbles on surface of
oil disappear). And rotate the crankshaft so that the
valves, cylinder liners and pistons etc. are all covered
with a layer of this oil. Then remount the intake and
exhaust manifolds.
- Remove sludge and dust from outer surface of the
engine. Smear anti-rust oil on to exposed machined
surface of parts of the engine. Rubber plastic compo-
nents are prohibited to be smeared with oil.
- Block the intake and exhaust manifolds with wrap up
them properly with plastic cloth in order to prevent
any dust from getting in.
- The engine so preserved should be stored in room
of good ventilation and low humidity but without any
dust. It is strictly forbidden to store the engine wherev-
er there are chemicals. The preservation according to
the above procedure may be good for three months.
Over this period, repeat this procedure.
14.2. Alternator Storage:
When an alternator is in storage, moisture tends to
condense in the windings. To minimize condensation,
store the generating set in a dry storage area. If pos-
sible use space heaters to keep the windings dry. After
removing the generating set from storage, perform an
insulation check
14.3. Battery Storage:
While the battery is stored, it should receive a refresh-
ing charge every 8 weeks up to a fully charged condi-
tion.
Aksa Power Generation will repair or replace, free of
charge, any part(s) of the equipment that is defective
in material or workmanship or both. Transportation
charges on product submitted for repair or replace-
ment under this warranty must be borne by purchaser.
This warranty is effective for the time periods and
subject to the conditions stated below. For warranty
service, find the nearest Authorized
Service Dealer,
15. DEAR AKSA GENERATING SET OPERATOR
PLEASE TAKE CARE TO THE FOLLOWING ORDER
TO PREVENT THE GENERATING SET WARRANTY
TO BECOME INVALID BEFORE THE TERMINA-
TION OF THE WARRANTY PERIOD AND TO EN-
SURE TROUBLE-FREE OPERATION OF THE GEN-
ERATING SET WITH A LONG LIFE!
• MAINTENANCE AND REPAIR WORKS WILL
NOT BE COVERED BY THE WARRANTY CERTIFI-
CATE, INVOICE OR DELIVERY CERTIFICATE OF
THE GENERATING SET IS SUBMITTED.
• THE WARRANTY OF THE GENERATING SET
WILL BECOME INVALIDE IN CASE OF ANY IN-
TERVENTION OF ANY PERSON OTHER THAN
AUTHORIZED AKSA SERVICES OR BY PRIOR
WRITTEN APPROVAL FROM AKSA POWER GEN-
ERATION ON THE GENERATING SET FOR ANY
REASON.
Altitude
(m)
0
500
1000
2000
3000
4000
25
1
0.93
0.87
0.75
0.64
0.54
Ambient temperature (˚C)
30
0.98
0.91
0.85
0.73
0.62
0.52
35
0.96
0.89
0.82
0.71
0.6
0.5
40
0.93
0.87
0.80
0.69
0.58
0.48
45
0.90
0.84
0.78
0.66
0.56
0.46
Содержание APD12A
