Page 2
Product Ratings
Electrical Specifications
MOTOR
12-VOLT SYSTEM (11-14 Volts DC)
24-VOLT SYSTEM (22-28 Volts DC)
Maximum
Operating Current
Normal*
Operating Current
Maximum
Operating Current
Normal*
Operating Current
Rotation
14 Amps
3-10 Amps
7.5 Amps
2-5 Amps
Elevation
14 Amps
3-10 Amps
7.5 Amps
2-5 Amps
Swing Arm
14 Amps
3-10 Amps
7.5 Amps
2-5 Amps
Pattern**
3-10 Amps
0.7-5.0 Amps
1.5-5.0 Amps
0.4-2.5 Amps
* Normal operating currents depend on operating conditions such as pressure, flow, etc.
** Pattern currents depend on the type of nozzle being used.
Mechanical Specifications
Parameter
U.S. Measure
Metric
Measure
Maximum Flow Rate
1250 GPM
4800 LPM
Maximum Pressure
200 PSI
14 Bar
Mass
55 Lbs.
25 kg
Tools Required
• Wrench for flange mounting bolts
• 1/2” hex head wrench in case there is a need to change the hard stop locations
Safety Symbols
Indicates a hazardous situation which, if not avoided, WILL result in death or serious injury
Indicates a hazardous situation which, if not avoided, COULD result in death or serious injury
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury
Addresses practice not related to personal injury
Product Warnings, Cautions and Notices
Use only for firefighting by trained operators.
Charge the unit slowly. Rapid charging may cause a pressure surge that has the potential to cause
an injury, or damage the monitor.
Do not stow or deploy the monitor while flowing. Pressing the Stow or Deploy button causes the
nozzle to move automatically and the water stream may cause damage to equipment or injury
to personnel.
Aim the unit in a safe direction before pumping water through it, e.g., away from power lines.
Do not use the electric controls when the manual override cranks are being used or are in
position for use.
Do not exceed the maximum pressure or flow ratings of the monitor. Exceeding these ratings may
lead to an injury or may cause damage to the monitor.
