3516526A02 Ed. 01
2
AKO Electromecánica thanks you and congratulates you on the purchase of our product, the development and manufacture of which involved
the most innovative technologies, as well as rigorous production and quality control processes.
Our commitment to achieving customer satisfaction and our continuous efforts to improve day by day are confirmed by the various quality
certificates obtained.
This is a high performance, technologically advanced product. Its operation and the final performance achieved will depend, to a great extent,
on correct planning, installation, configuration and commissioning. Please read this manual carefully before proceeding to install it and respect
the instructions in the manual at all times.
Only qualified personnel may install the product or provide technical support.
This product has been developed for use in the applications described in the manual. AKO Electromecánica does not guarantee its operation in
any use not foreseen in this document and accepts no liability in the case of damage of any type which may result from incorrect use, config-
uration, installation or commissioning.
Complying with and enforcing the regulations applying to installations where our products are destined to be used is the responsibility of the
installer and the customer. AKO Electromecánica accepts no liability for damage which may occur due to failure to comply with these regulations.
Rigorously follow the instructions described in this manual.
In order to extend the lifetime of our products to the maximum, the following points must be observed:
Do not expose electronic equipment to dust, dirt, water, rain, moisture, high temperatures, chemical agents or corrosive substances of
any type.
Do not subject equipment to knocks or vibrations or attempt to handle them in any way differently to that indicated in the manual.
Do not under any circumstances exceed the specifications and limitations indicated in the manual.
Respect the indicated environmental conditions for operation and storage at all times.
During installation and on completion of this, avoid the presence of loose, broken or unprotected cables or cables in poor condition.
These may constitute a risk for the equipment and its users.
AKO Electromecánica reserves the right to make any modification to the documentation and the product without prior notification.
Index
Page
Warnings ............................................................................................................................................. 3
Maintenance ........................................................................................................................................ 3
Presentation ......................................................................................................................................... 4
Description ........................................................................................................................................... 5
Installation ..........................................................................................................................7
Wiring .................................................................................................................................................. 9
Initial configuration ............................................................................................................................. 10
Superheating SET POINT ...................................................................................................................... 11
Assistant ............................................................................................................................................ 11
Operation ............................................................................................................................................ 13
SELFDRIVE mode ................................................................................................................................. 16
Cold regulation ................................................................................................................................... 17
Compressor protection timing .............................................................................................................. 21
Door management .............................................................................................................................. 22
Management of door frame resistor ..................................................................................................... 22
Defrost ................................................................................................................................................ 23
Management of the drainage resistor .................................................................................................. 27
Evaporator fans ................................................................................................................................... 27
Alarms ................................................................................................................................................ 28
Alerts .................................................................................................................................................. 30
Light control ........................................................................................................................................ 31
Password ............................................................................................................................................ 31
Remote Stand-by mode ....................................................................................................................... 31
Operation of the auxiliary relays........................................................................................................... 31
Configuration ...................................................................................................................................... 33
Extended programming menu .............................................................................................................. 34
Parameters .......................................................................................................................................... 35
Connectivity ........................................................................................................................................ 41
Technical specifications........................................................................................................................ 42