AKG C 900-TM 40, Инструкция пользователя

Страница: 15 / 64

Note:
2.5 Optional
TM 40 Transmitter
Module
Start by removing
the XLR connec-
tor module:
Fig. 4: Removing
the XLR connector
module.
Refer to fig. 4.
Install the trans-
mitter module:
Refer to fig. 5.
Fig. 5: Installing the
transmitter module.
Use a cable with a female XLR connector and TS jack plug:
1. On the XLR connector, use a wire bridge to connect pin 1 to
pin 3 and the cable shield.
2. Connect the inside wire of the cable to pin 2 on the XLR
connector and the tip contact of the jack plug.
Unbalanced cables may pick up interference from stray mag-
netic fields near power or lighting cables, electric motors, etc.
like an antenna. This may introduce hum or similar noise when
you use a cable that is longer than 16 feet (5 m).
The optional TM 40 transmitter module allows you to convert
your microphone into a wireless microphone that you can use
with any WMS 40 Series receiver from AKG.
1. Open the fixing screw (1).
2. Pull the XLR connector module (2) out of the microphone
body.
3. To avoid losing the fixing screw (1), screw it into the thread-
ed hole (3) in the XLR connector module.
2 Interfacing
15
1
2
1
2
3511_C900M_fsch.qxd 12.07.2006 20:25 Uhr Seite 15