Installation User
Manual
Tx800
20 E-EQ-TX800OGWW-D-ARC
The input and output blocks each have two + and two – minus connectors. Either connector in
the block can be used to connect the matching polarity wire.
Use the looms and wire ties to secure all wiring then reattach the cover with the screws.
6.
If the blackout screen box is used, attach the stripped wire
ends to the box. Refer to section 4.2.3 and the label on the
blackout screen box for proper wiring connection.
7.
Connect the DC to DC converter to the vehicle’s electrical system.
8.
While observing the fuse requirements specified above, connect the power cable as close as
possible to the actual battery terminals of the vehicle. When available, always connect to
unswitched terminals in vehicle fuse panel, after providing proper fusing.
ATTENTION:
For uninterrupted power, electrical supply connections should not be made at
any point after the ignition switch of the vehicle.
9.
If used, connect the wiring for the blackout screen box.
10. Use proper electrical and mechanical fastening means for terminating the cable. Properly sized
“crimp” type electrical terminals are an accepted method of termination. Please select electrical
connectors sized for use with 18AWG (1mm
2
) conductors.
11. Provide mechanical support for the cable by securing it to the vehicle structure at approximately
one foot intervals, taking care not to over tighten and pinch conductors or penetrate outer cable
jacket.
Содержание Tx800 Triton
