AKE Bluetooth helmet set 101, Инструкции по эксплуатации и монтажу

Страница: 18 / 24

18
ENGLISH
mouth the microphone should be put on an additional foam padding!
Mark in your helmet the selected place for the microphone and clean the
padding in the area of the bonding surface, remove the protective paper and
press the microphone firmly onto the helmet.
For flip-up helmets flexible microphone spiral cords are available. Then the
microphone cable should be laid in such a way that the elastic part will connect
the flexible parts of the helmet and that it runs on the side of the sight area from
the bottom up when the helmet is closed.
For open helmets also gooseneck (boom) microphones are available, see
optional accessories on page 24
Placement and replacing of rechargeable battery
Charging of battery
The high quality Litium-Ionen/Polymer battery is very small and light and can
easily beLeft ions Akkus unload themselves automatically, do not forget you not
before the use the accumulator to load. If the accumulator longer time were not
loaded, is it possible that load electronics starts not directly, please puts you then
the plug of the battery charger several times in and. After some attempts the
loading procedure should be started.
put between or under the padding. The battery is connected via cable and plug
with the electronic box. The advantages are as follows:
1. defective batteries can easily be replaced
2. on tours the empty batteries can be replaced by recharged exchange batteries
3. alternatively, more powerful batteries can be used.
Li-Ion batteries self-discharge, do not forget to charge the battery before using it.
If the battery had not been charged for a longer time, the electronics for charging
might not start directly. Then, please put the plug of the battery charger in and out
several times. The charging procedure should start after a few tries.
20 minutes = minimum charging
2 hours
= total charging
These parameters are for standard batteries only. For charging time of other
batteries please refer to the respective data sheets. The display will show a red
light when charging. The helmet set should be fully charged for an optimum
performance.