AKE Bluetooth helmet set 101, Инструкции по эксплуатации и монтажу

Страница: 17 / 24

17
ENGLISH
Important Before you start mounting, please read the following lines
carefully
The assembly is according to the type of helmets used. First, check the padding in
the area of the ears. The closer the loudspeakers are to the ears the better is the
quality of the sound!
Most of the time the loudspeakers are placed under the foam padding for better
wearing comfort. It is very important that thick padded helmets have their
padding perforated in this area.
Mark in your helmet the place where your earlap is located. Then you can
proceed as follows: Take a piece of insulating tape and put it where you think your
earlap is located. Then put on the helmet and prove with your finger if the
marking is at the exact place. Don’t settle for less than the exact spot. This is the
only way to get the full advantage of all components!
Now remove the protective paper on the back of the loudspeakers (self-adhesive)
and put them exactly below the markings in the helmet (connector pointing
towards the chosen side for the helmet connection) by putting a smooth pressure
on the edge of the earpieces. The bonding surface has to be clean and even.
The microphone is provided with a special close talking capsule to efficiently
compensate the driving noise.
You can only take advantage of this technique when installing the microphone
centrically in front of the mouth. Helmets that have a lot of space in front of the
If you are not sure, please ask your authorized
AKE dealer or contact us directly.
!
and mind safety advices!
When using helmets with neck guard, the ergonomically designed Bluetooth and
booster box can be put invisibly inbetween neck guard and helmet padding on
the left side. An additional fixing will not be necessary. When using helmets
without neck guard, the electronic box could be affixed to the reverse side of the
helmet with the enclosed velcro fastener.
Installation of electronic box
Assembly of the helmet loudspeakers
Assembly of the helmet microphone
Attention
Never install components in such a way that the protection effect of
the helmet is limited!