OG-DANTE-12GAM openGear Card v1.1.0 13 www.aja.com
Figure 9. The white plastic tab for the card on the right is now upright. Both
cards are shown fully inserted.
5. Close the frame door as follows:
A. Slide the door into the frame.
B. Pull and release the door tabs to ensure the frame door is securely locked
to the frame.
Cabling
Refer to
to identify the input and output signal connectors.
After installing the OG-DANTE-12GAM with its rear card into your openGear frame
and connecting your SDI inputs and outputs, connect a Cat5 or Cat6 Ethernet
cable from your applicable network to the Ethernet Primary port on the rear card.
NOTE: The Ethernet Secondary port is used only for a secondary redundant network
connection that must be on a separate network. Dante Controller will not
function correctly if the Primary and Secondary Ethernet Ports are connected to
the same network switch.
