AJ Aircraft Raven 73", Руководство по сборке

Страница: 9 / 26

aj-aircraft.com Page 8
With the control horn in position apply painter ’ s masking
tape around the control horn base. Put the tape up to
the base edge. Not under or over it.
Assemble a rod end to the control horn using a supplied
2mm machine screw and nylon lock nut. Assembling the
ball link to the control horn at this step will help keep the
control horn halves parallel during installation later.
Remove the control horn leaving the tape in position.
Using a new hobby knife blade and lightly cut through the
covering but not into the balsa sheeting.
Cut inside the tape edge about 1/16”.
Use sand paper to roughen the lower portion of the
control horns on both sides. Roughen one side of the
base plate. This will help the epoxy bond to the control
horn parts.
Apply epoxy to the slots in the aileron. Use a pin to help
push some epoxy in.
Apply epoxy to the control horn assembly and insert it
into the aileron slots.