AIS AutoChlor Classic LS Series, Инструкция по эксплуатации

Страница: 12 / 24

12
WARNING INDICATOR LIGHTS
(FIG. 1, ITEMS 1, 2, 3 & 4)
There are four (4) warning indicator lights located on the front of your chlorinator. These advise
at a glance the status of the chlorinator power supply and, when illuminated they indicate and
advise about the situation that the chlorinator’s electronic monitoring system
has detected. The lights and their functions are listed below.
1. ORANGE LIGHT: SALT HIGHER THAN NECESSARY
no action required
When illuminated this indicates that you have exceeded recommended salt levels. As long
as this is not causing your chlorinator to overload no further action or reduction of salt
concentration is required at this point. No further salt should be added if this light is illuminated.
2. ORANGE LIGHT: STEADY CELL OFF
chlorinator on standby
FLASHING SALT LOW
add salt and/or clean cell
STEADY – When illuminated in a STEADY continuous light your chlorine production has been
switched off by turning the chlorine controller anti clockwise and your chlorinator power supply
is now in a standby mode. Turn the chlorine controller clockwise to resume normal operation.
FLASHING – If the light is illuminated and FLASHING the monitoring system has detected low
salt levels and this will need to be adjusted for the chlorinator to operate at maximum capacity.
This light will also flash if the cell has reached a point where its output is below the normal
operating output. Please refer to the section detailing the addition of salt to your pool.
3. RED LIGHT: STEADY POWER ON
FLASHING NO WATER FLOW
chlorinator on standby
STEADY – During normal operation this light will remain STEADY, indicating that power is on
and the chlorinator is operating correctly.
FLASHING – When FLASHING the monitoring system has detected a water flow problem and
has shut down to prevent damage. It will also be accompanied by a beeping alarm alerting you
of this situation. When problem is rectified normal operation will resume.