Scholar V Installation & Startup Manual 07/2016 New
36
APPENDIX B - BASE STAND INSTALLATION
1.01 TOOLS/FIELD FURNISHED SUPPLIES
WARNING
TO AVOID PERSONAL INJURY, ADEQUATE PROTECTIVE CLOTHING MUST BE WORN
AND PRECAUTIONS IN HANDLING AND INSTALLING THIS EQUIPMENT MUST BE
PRACTICED AT ALL TIMES.
• Power Drill/Driver and Extension
• Bit for 5/16” Hex Head Bolts (or Adjustable Wrench)
• Appropriate Bits for Boring Anchor Holes and Fastening Anchor Bolts Through 1/2”
Pass Through Holes in Base Stand (4 Locations)
1.02 INSPECTION/UNPACKING/HANDLING
Base stands are shipped to the job site on wooden skids and are enclosed in shrink
wrap. Do not stack the base stands.
IMPORTANT
IMMEDIATELY UPON RECEIPT, INSPECT THIS EQUIPMENT TO DETERMINE VISIBLE
AND CONCEALED DAMAGE. ALL DAMAGE MUST BE REPORTED TO THE FREIGHT
CARRIER WITHIN 15 DAYS, ON THE FREIGHT CARRIER’S FORM.
The label on the base stand identifies the part number of the base stand.
Base Stand
Height
Part Number
2”
S/06849
4”
S/06850
Remove the shrink wrap from the base stand and dispose of the wooden skid.
Retain the bag of 5/16” bolts and flat washers to fasten the cabinet to the base
stand.
Do not install the Scholar V heat pump or air conditioner to the base stand
at this time.
Place the base stand (as shown in Figure 1) on the floor, measuring carefully to
determine the exact location, based on where the heat pump or air conditioner is
intended to be placed. It is important to be sure of base stand location when the unit is
going to be located set off from the finished inside wall. The unit will be located directly
on top of the base stand, and the base stand will be anchored to the floor.
