AirWild Hobbies Almost-ready-to-fly 29% Extra 260, Инструкция по сборке, Страница: 9 / 28

For your convenience we have created a sheet of DA50-R mounting bolt pattern template to
simplify your work. Simply cut out the template, superimpose it onto the firewall and locate the
mounting holes that way.
Mounting Holes Located & Drilled DA Standoffs Installed
(0.25” plywood spacers not shown)
DA50-R Installed
(0.25” plywood spacers not shown)
Installing the DA ignition module is the next thing to do. The ideal place for ignition module is
on the bottom surface of the engine box, as shown in the illustration below
DA50-R Ignition Installation Guide
1. Turn the airplane upside down to have the bottom of the
engine box facing up.
2. Place ignition module in the middle of the surface. Mark
and cut two slots to be used for strapping down the ignition
module. We prefer using Velcro strip to for this application.
3. Apply thin CA to the perimeter of the slot. This will reduce
chances of plywood splitting. Harden with CA Kicker.
4. Use Velcro strip to secure ignition module as illustrated.
Cushion the module with a piece of foam.
5. Drill a hole through the bottom surface to route the battery
connector of the ignition module to the inside of the engine
box where the ignition battery will situate.
Doc. No.# AW70-105-01, Rev. 3 Copy Right 2006, AirWild Hobbies, Inc. Page 9