AirWild Hobbies Almost-ready-to-fly 29% Extra 260, Инструкция по сборке, Страница: 19 / 28

9. Sandwich a 1/4 HD ball link between the two horns as
shown. Retain the ball link by threading the #4-40 SHCS
through both horns and ball link and lock in place with the
#4 lock nut. This keeps two horn parallel to each other and
creates a slop-free joint between control horns and ball link
which is critical to the precision of elevator movement.
Doc. No.# AW70-104-01, Copy Right 2004, AirWild Hobbies, Inc. page 19
10. Once again re-check horn alignment. When satisfied, glue
both horns in place with thin CA. Saturate the balsa core
with thin CA and then harden it with CA Kicker.
This step
is very critical as it dictates the bonding strength of the entire setup. If your slots are
too loose, use gap-filling medium CA to fill the voids. When all is done, remove ball link.
11. Repeat 3~10 for the other stabilizer / elevator pair.
E E l l e e v v a a t t o o r r S S e e r r v v o o & & P P u u s s h h R R o o d d I I n n s s t t a a l l l l a a t t i i o o n n
Elevator servo slot has been
precut to accept standard-size
servo. Illustration on the right
demonstrates our intended
configuration. Refer to illustration
often as we proceed. Let’s work
on the right elevator first. Repeat
for the left elevator.
Servo Type: metal gear, 100 oz. in. output torque minimal, digital servo preferable
Servo Arm: aluminum half arm, 1.25” length
5. Drop in elevator servo and orient it so that the servo output shaft is closer to the elevator
leading edge.
6. You will need to attach an extension lead to the servo in order to route lead to receiver.
Exact length of the extension depends on your receiver placement. If you are following
AirWild’s default setup, now is the time to attach an 18” extension to the servo. Use a
piece of dental floss to secure the interconnect.
7. Construct elevator push rod. We recommend the following
components which are included in our optional hardware
package;
„
AirWild Carbon Fiber Push Rod x1 AirWild #AW60-200-01
„
1/4 HD Ball Link x2 DuBro #899
8. Install servo arm. Orient servo arm at 90 degrees to servo
case. Hook up servo to receiver and turn on transmitter while performing this setup for
reason mentioned previously.
9. Hook up push rod to servo arm and EFP control horns. Adjust the turnbuckle push rod
until elevator is in neutral and servo arm is at 90 degrees to the servo body.