Page 22
Step 2: Unfastening the operation panel
and detaching the filter
1.
Open the packaging and take out the indoor
unit. Remove the protective tape and any
components.
screw bolt fixing hole
2.
Open the two boxes for storing the remote
control found on either side of the indoor
unit, then undo the screws on the operation
panel.
3.
Use both hands to gently hold the decorative
part at the top of the operation panel, then
lift it upwards to remove it along with the
wire terminal which is connected to it.
4.
Undo the two screws on the front of the filter.
5.
Use both hands to hold the two sunken areas
on either side of the filter and pull away from
the unit. Lift the filter upwards to remove it.
6.
Please take off the air-inlet grid before
connecting the pipes/wires.
First remove the screws cover, then remove the
screws on the air-inlet grid, then take off the grid.
7.
Remove all of the accessories placed inside
the bottom cavity of the indoor unit.
Step 3. Remove the fasteners from the roller
(only found on selected models)
1.
Check to see whether the roller on the indoor
unit has any fasteners holding it in place and
tear off the notice sticker.
2.
Remove the fasteners from the roller
according to the directions on the sticker.
1. Measure the position of the holes for
installation.
2. Insert the M8 bolts into the unit while it is on
the floor (the amount of bolts used depends
on the number of holes on the unit's chassis).
3. Lift up the indoor unit so that the installation
holes cover the bolts, then fasten the nuts
onto the bolts and tighten them.
8.
Check that all of the accessories match those
found on the “Installation Diagrams and
Accessories” as shown on the previous page.
Step 4. Fastening the indoor unit (to prevent
it from falling down)
•
Take out the protective wedge and
measure the correct size.
•
Use the self-tapping screws to fasten the
protective wedge to the top cover of the
indoor unit.
•
Fasten the other end of the wedge tightly
to the wall using the self-tapping screws.
If further support is needed to prevent the
unit from falling down, a protective wedge
can be installed. The installation procedure
for this wedge is as follows:
1. Remove the metal rodent-proof mesh from
the piping found on the unit by gently
tapping on it.
Step 5. Installing the rodent-proof mesh
Air-inlet Grid
CAUTION
Indoor Unit
Installation
