50mm
min
50mm
min
PNV 015
PNV 018
PNV 021
3
UNIT INSTALLATION
Unit offers five directions for installing refrigerant pipe, please installing the unit according to following installtion:
1. Knockout hole and pull out the pipes.
4. Purifying filter installation (optional).
2. Install the unit to wall.
5. Check the drainage.
3. Secure the unit.
Pull out the piping and hose
Install the Indoor Unit
1.Hook the indoor unit onto the upper portion of
installation plate (Engage the indoor unit with the
upper edge of the installation plate). ensure the
hooks are properly seated on the installation plate
by moving in left and right.
2.Used the installation support that assemble to the
unit housing to support the indoor unit in a angle
about 25", than connected the piping and power
supply cord.
Move the drain hose near
to arrow mark and tape it
with piping in a position as
mentioned in Fig. below
Cover for the
right piping
Cover for the
bottom piping
Cover for the
left piping
Drain hose
Piping
Piping direction
Right
Right rear
Right Bottom
Left Rear
Left
(Front side)
Hooks at
installation plate
Piping
Drain hose
Fig 1-2
