Airstream 2009 Pan America, Руководство пользователя

Страница: 59 / 135

C - 24 C - 25
C
CAMPINg
3. When the front pins hits the bracket pin stop lower the end of the ramp to
the ground, Figure 2. Always position the loading ramp so the ends in contact
with the ground are level or at the same height. An uneven ramp may cause the
cargo to tip over sideways during loading/unloading.
4. Raise the front of the ramp on one side until the front pin is aligned with the
ramp bracket locking slot channel, move the ramp slightly forward and up into
the locking slot and lower the ramp so that pin is hooked in the bracket locking
slot securely, Figure 3. Repeat this procedure for the other side. Ramp should
be almost level with cargo door jamb if properly placed in the bracket locking
slots.
5. Once both front pins are resting secure in the bracket locking slots, lift the
rear of the ramp and try to pull it away from trailer. If the ramp moves check that
the front pins are located properly in the bracket locking slots.
6. Lower the ramp storage door onto the ramp.
To replace the ramp into the storage compartment:
1. Raise the front side of the ramp up to unhook the pin from the locking
bracket and slide the ramp back until the pin is resting in front of the bracket
pin stop and in the pin channel. See Figure 4. Repeat procedure on the other
front side.
2. Lift rear of ramp up to level and slide it back into storage compartment once
again maintaining a level, square attitude to trailer.
3. When rear pins hit the bracket pin stop lift the rear of the ramp up slightly
and push the ramp into the compartment until the pins fall down into the pin
channel and in front of the bracket pin stops.
4. Close and latch the storage compartment door.