Use and maintenance manual Self-propelled aerial platforms Page 37
6
HANDLING AND CARRYING
6.1
Handling
To handle the machine in normal operating conditions follow the instructions given in chapter "GENERAL USE
INSTRUCTIONS" under paragraph "Drive and steering”.
When the platform is completely lowered (or within a given height according to specific needs and further to checks) the
machine can be handled (i.e. drive can be performed) at different speeds to be freely selected by the user.
With platform at a given height, the drive speed is automatically limited, and cannot be changed.
The section TECHNICAL FEATURES indicates the limits concerning drive for each model.
CAUTION! Drive with lifted platform may be subject to different restrictions according to the country
where the machine is used. Find out about the legislative limits concerning this manoeuvre from the
bodies of Health and Safety at work.
It is absolutely forbidden to drive the unit when the platform is lifted unless the ground is horizontal, flat
and steady.
Check that there are no holes or steps on the floor and bear in mind machine overall dimensions.
Before any movement, verify the presence of people in close proximity to the machine and, in any case,
proceed with the utmost caution.
Before any movement make sure that the machine plugs are disconnected from the power source. On
machines with AC electric pump (optional) always check the position of the power cable during the
movements.
While de-placing the unit with lifted platform do not load horizontal loads onto the platform (the operators
on board must not pull ropes, wires, etc.).
6.2
Carrying
In order to carry the machine to the various working sites, follow the instructions given below.
Considering the large dimensions of some models, before carrying, it is recommended to inquire about the overall dimension
limits for road transport in force in your country.
Before carrying the machine, turn it off and remove the keys from the control panels. No people are
allowed in proximity to or on the machine to avoid any risks deriving from sudden movements.
For safety reasons never lift or tow the machine by means of its booms or platform.
Loading operations are to be carried out on a flat surface with a suitable capacity, after setting the
platform to rest position.
To carry the machine the operator shall load it onto a vehicle either:
1)
By means of chutes and translation controls
located on the platform to load it directly onto the vehicle - if ramp slope
is within the gradeability described in paragraph “TECHNICAL FEATURES” and capacity is adequate to weight -
according to the instructions given in chapter “GENERAL USE INSTRUCTIONS” under paragraph “Drive and steering”
for the correct operation of drive controls. If the slope exceeds the gradeability, the machine is to be towed by means of a
windlass only if the operator on the platform simultaneously activates the drive control to release the parking brakes.
