5
User manual – Controller CP Touch
The back of the controller board has jumpers at designated points as shown in Fig. 2:
T.CAN – A termination resistor jumper; the jumper must be fitted on the last
controller in line.
A1
– 1. Controller addressing jumper
A2
– 2. Controller addressing jumper
The jumpers of each controller on the same bus bar must have different address.
Table 1 shows controller connection options. When more controllers are installed,
their addressing must be different. The last controller in the series must be
terminated with a T.CAN jumper.
Number of
controllers
connected
A1
A2
T.CAN
1
0
0
1
0
0
0
2
0
1
0
0
0
2
0
0
3
0
1
0
0
0
2
0
0
3
0
0
4
Table 1
0
…………..Unconnected jumper
…………Connected jumper
2
Controller description and functions
Turn on the light of a connected controller by clicking on the dark screen.
The CP Touch controller can be connected to DUPLEX units fitted with an RD5 control
board. The CP Touch provides full control for these units, i.e. service parameter
settings, protected by a password.
The controller enables:
– A manual mode, allowing the user to choose directly the operating mode of the
unit.
– A weekly mode to control the unit according to a weekly program.
