7. Access Management
45
AirLive WT-2000ARM User’s Manual
Parameter
Description
IP/ MAC Filter Set
Index
This is the item number to record the setting.
Interface
Select which channel (PVC) to configure.
Direction
Select the access to the Internet (Outgoing) or from the Internet
(Incoming), or Both.
IP / MAC Filter Rule
Index
This is the item number to record the setting rule.
Rule Type
Select to filter through the IP Address or MAC Address
Active
Select “Yes” to enable the current rule, select “No” to cancel the
current rule.
Source IP Address
Enter the start IP Address which will be monitored. If “0.0.0.0” is
set, it means for any IP Address.
Subnet Mask
Enter the Subnet Mask based on the Source IP Address.
Port Number
LAN users use port numbers to distinguish one network
application over another such as 21 is for FTP service. The port
number range is from 0 to 65535. It is recommended that this
option be configured by an advanced user.
Destination IP Address
Enter the start IP Address which will be monitored. If “0.0.0.0” is
set, it means for any IP Address.
Subnet Mask
Enter the Subnet Mask based on the Destination IP Address.
Port Number
This is the port or port ranges that define the application.
Protocol
It is the packet protocol type used by the application. Please select
“TCP”, “UDP” or “ICMP”. For example, FTP service, you have to
select “TCP”.
MAC Address
The MAC Address (Media Access Control address) is a hardware
address that uniquely identifies each node of a network. If the rule
is “MAC”, you have to designate the MAC address that you want to
filter.
Rule Unmatched
Select action for the traffic unmatched current rule. “Forward” is to
leave it pass through; “Next” is to check it by the next rule.
IP/MAC Filter Listing
The IP Filter Listing will list the IP Filter rules you have configured.
You can review the settings here.
