y
If Filtering is enabled and Filter Type is “
Allow AII Except Those Listed Below
”, those devices
with a MAC address which has been entered in the MAC Address listing will NOT be able to
communicate with the AP.In this case, navigate to the report: Wireless Clients and copy the MAC
address of any wireless Client that you want to exclude from communication with the AP and input
those MAC Addresses to the MAC Address list.
8.4 Auto Bridge General Settings
Items
Parameters
Description
Wireless Bridge – General Page
SSID
The SSID of bridges those you want to link
together need be same.
Max Auto Bridges
1 ~ 40
Maximum number of auto bridge allowed
Bridge Priority
1 ~ 40
Determines the root device. The lowest bridge
priority in the network will become the root
device of bridge network topology.
Signal Strength Threshold
I
f the signal strength of remote node is blow this
threshold. The link will be dropped.
Broadcast SSID
Default on to enabled bridge will use SSID for
token for communication. If don’t like SSID be
exposed, it can be disable. However both setting
must be same, otherwise the devices cannot
bridge together.
Wireless Bridge – Radiol Page
Wireless Mode
802.11b/g Mixed
802.11g Super
802.11a
802.11a Turbo
Tx Rate
Auto
6, 9, 12, 24, 36, 48, 54 Mbps
When set to AUTO, the unit attempts to select
the optimal rate for the channel. If a fixed rate is
used, the unit will only transmit at that rate.
Channel Number
Set the channel frequency for the wireless
bridge. The bridges those you want to link
together need be same channel frequency
Tx Pwr Mode
It is same as AP, support Off, Fix and Auto
modes. At Fix mode, there are 5 signal levels
you can select (1 being the smallest power
level). If you want to prevent any radio frequency
transmission, set Tx Pwr Mode to off.
Propagation Distance
< 5Miles
5~10 Miles
11~15 Miles
16~20 Miles
21~25 Miles
26~30 Miles
> 30 Miles
Set the distance based on the distance between
this bridge and furthest bridge that is connected
to it
AirLive WH-9000-MESH User’s Manual
46
