SECTION 5
Attaching the Chimney
1. Mark the location for the vertical chimney bracket:
If using the upper chimney section: 9-3/4"
If not using upper chimney section: 15-3/4"
2. If installing onto drywall, drill holes into wall using a 3/16" drill bit. Install wall anchors into
the drilled holes (one for each hole). Secure bracket into place with (2) provided #6 x 1"
screws. If installing into other material (brick, cement, plaster, etc.) choose an appropriate
fastner capable of supporting the weight of the chimney
(Figure 5).
3. Press in appropriate tabs on lower chimney section (section with vent holes). If using the
upper chimney, press in tabs in middle of the chimney (Position A), otherwise press in tabs
at top of the chimney (Position B). Press in tabs at the bottom of the chimney so there is
approximately 1/4" of clearance
(Figure 6).
www.airkinglimited.com
6728025 Rev. K 1-16
3 of 12
Figure 4
Hot (Black)
Neutral (White)
Supply from home
From Hood
NOTE:
If the top chimney section (included) will be installed, slide the top section inside of the
bottom section at this point.
3. Slide chimney in place so top tabs of the chimney are secured in place on the indents of the
vertical chimney bracket and the backside of the chimney fits between the hood and the wall
with the bottom tabs overlapping the back lip of the hood
(Figure 7).
4. To install the upper section, mark the location of the included horizontal mounting bracket
using the bracket as a template. Make sure the bracket is level and in line with the bottom
section. The height will be dependent on your installation requirements. Make sure the slots
in the side of the chimney will match the holes in the mounting bracket. If installing onto
drywall, drill holes into wall using a 3/16" drill bit. Install wall anchors into the drilled holes
(one for each hole). Secure bracket into place with (2) provided #6 x 1" screws. If installing
into other material (brick, cement, plaster, etc.) choose an appropriate fastner capable of
supporting the weight of the chimney
(Figure 8).
Figure 6
Hot (Black)
Ground (Green or Bare)
Wire
Compartment
Figure 8
A
A
B
B
Details of duct collar, ducting, and electrical have been
omitted from drawing for clarity purposes.
Figure 7
Mounting
Bracket
Neutral (White)
Ground
(Green or Bare)
Side View
Vertical Chimney
Bracket
9-3/4
"
or
15-3/4
"
Details of duct collar, ducting, and electrical have been
omitted from drawing for clarity purposes.
Figure 5
