page 5
INSTALLATION GUIDES
PRECAUTIONS
Be careful and take necessary measures to prevent gases from slipping out into the room via any air vent or other
open flames equipment.
Avoid the following situation during installation to prevent from abnormal loud noise or possible drop in wind speed.
(1) Too much bending
(2) Multiple bending (3) Reducing the diameter of the ductings
Prohibited
Prohibited
Prohibited
4. Wiring the 86 Box Control Kit
Connect the wires for the 86 Box Control Kit to the wire vent
and switch box.
The two ends of the wire has different connecting power plug.
Make sure the right end is connected to the right power plug
for the main unit as well as for the 86 Box Control Kit.
To Main Unit
To 86 Box
Control Kit
5. Connecting the Cloth Line & 86 Box Control Kit
Connect the Cloth line and the 86 Box Control Kit according to
the Line Schematic Diagram on page 8
Copper Wire
Connecting
Earth Wire
Fixed Cloth Line
Unit (in mm)
86 Box Control Kit Wire
Power Supply Wire Cap
Earth
Wire
Live
Wire
Connecting
Rod
Screws
86 Box Control Kit Wire
86 Box Control Kit Wire
B. 86 BOX CONTROL KIT INSTALLATION
1. Remove the back cap
a. Use the Slotted Head Screw Driver to pry
open the back cap of the 86 Box Control Kit
from the side as indicated in the diagram.
b. Pull out the connecting wires from the base of
the 86 Box Control Kit, and pulls it through the
lower cap of the 86 Box Control Kit and secure
the lower cap to the base using screws. Finally
connect tightly the power plug to the circuit
board on the upper cap of the 86 Box Control
Kit.
86 Box Control Kit
Power Plug
86 Box Control Kit Base
86 Box Control Kit Back Cap
Screws (M4x16)
Remote Control
Interface
Neutral
Crimping plate
