17
AIRCLEAN
®
SYSTEMS CART ASSEMBLY INSTRUCTIONS
Model ACA1011 and ACA1039
Your AirClean
®
Systems Cart is shipped with the following components:
4 - Cross pieces
8 - 1¼” washers (cross piece washers)
2 - End pieces
4 - Casters
8 -
Hook & Loop Fasteners (4 Hook, 4 Loop)
8 - 2” x ¼” Phillips head bolts
(cross piece bolts)
ASSEMBLY OF CART
1. Locate a cart end piece and one cart cross piece. Place one
3
/
8
” washer on to a 2”
phillips head bolt.
2. Starting with hole one on the cart end piece place washer and bolt through the hole
and into the threaded receiver of the cart cross piece. Hand-tighten only until cart is
completely assembled.
3. Repeat steps above for holes 2 and 3.
4. For standard setup complete assembly using hole 4. For seated use complete
assembly using hole 5.
5. Tighten all bolts completely.
6. Installation of casters should be per illustration on page 21.
MOUNTING OF ENCLOSURE TO ASSEMBLED CART
1. Remove the adhesive backing from one hook-side fastener and adhere to the top of the cart
end piece, one inch from the front.
2. Repeat step one, adhering the fastener one inch from the back.
3. Repeat steps one and two for the other cart end piece. There should be strips of hook-side
fasteners on all four corners of the top of the cart (see cart components diagram).
4. Attach loop-side fasteners to the hook-side fasteners and peel off the backing so the
adhesive is exposed on all four corners.
5. Carefully place the enclosure on the assembled cart, lining up the enclosure and cart edges.
6. Firmly push down on the edges of the base inside the workstation so the adhesive sticks to
the enclosure base.
OPTIONS
