Aircatglobal VirtualFly SOLO-A, Руководство пользователя

Страница: 13 / 24

13
5. RADIOSTACK PANEL - SOLO-A USER'S MANUAL
5.4. AUTOMATIC DIRECTION FINDER (ADF)
This is 100% functional; the ADF and BFO buttons are working but per-
form no actions.
(FS does not allow the user to move the needle to 90º
as would be usual in ANT mode) .
Frequency Mode (Frq)
In its main mode, it shows two frequencies: Used and Standby.
Flight Time Mode (FLT)
An internal chrono is started when the device is activated, and it counts
both Hours and Minutes. It always works (in any mode) while the device
is On.
Chrono Mode - Elapsed Time (ET)
The ET mode allows a chrono with Minutes and Seconds (until 59:59).
The chrono begins to count when you press SET/RST push button (also
when other mode is selected) and returns to start every time SET/RST is
pressed. Can not be stopped, always is reset to 0 and begins to count
automatically.
Countdown Mode (ET blinking).
A countdown of a maximum of 59 minutes, 59 seconds is allowed. To
enter countdown mode, the SET/RST pushbutton must be pressed and
maintained (with the mouse) for 2 seconds or longer, or until ET starts
to blink.
Subsequently, you should select the initial time with the rotatory knobs,
the big one to select the minutes and the small for the seconds, and
press the SET/RST pushbutton to start the countdown.
When the time reaches 0 the mode reverts to normal ET Mode and
begins to count up, but to advise you of the time blinks for 15 seconds.
The example picture shows 3 minutes in FLT mode.
Change
between
ADF & ANT
mode
In Use
Frequency
Enables
BFO
modulation
FQR
Mode
Enables FRQ
mode and Enables
BFO modulation
frequency transfer
Stand By
Frequency
FLT Mode indication (HH:MM)
ET Mode indication (MM:SS)
ET Countdown (MM:SS) ET Blinking
FLT and ET modes switch
Starts and reset the chrono,
and enable the countdown mode
Pressed > 2 seconds enables the
countdown mode (ET blinking).
Units
selector
Seconds
selector
Hundreds and
thousands
selector
Minutes
selector