Airbus TW1m, Инструкция по эксплуатации

Страница: 19 / 28

TW1m - Instruction Manual PS11730AENAD01
19/27
This document is the property of Airbus DS SLC and should not be copied or circulated without permission.
I N S T A L L A T I O N
7. INSTALLATION

Safety warnings and cautions
ESD protection
Airbus Defence and Space requires that the TW1m modem’s service points have sufficient ESD protection against
static electricity when servicing the product. Any product which has its covers removed must be handled with ESD
protection. To replace the covers, ESD protection must be applied. All electronic parts of the product are susceptible
to ESD.
All ESD-sensitive parts must be packed in metallized protective bags during shipping and handling outside any ESD
Protected Area (EPA).
Every repair action involving opening the product or handling the product components must be done under ESD
protection.
ESD-protected spare part packages MUST NOT be opened/closed outside of an ESD Protected Area.
For more information and local requirements about ESD protection and ESD Protected Area, contact your local
Airbus Defence and Space After Market Services representative.
WARNINGS:
1. If the device is installed in a vehicle, care must be taken on installation in vehicles fitted with electronic
engine management systems and anti-lock braking systems. Under certain fault conditions, emitted RF
energy may affect to operation of these systems. If necessary, consult the vehicle dealer/manufacturer to
determine the immunity of vehicle electronic systems to RF energy.
2. The radio must not be operated in areas likely to contain potentially explosive atmospheres, for example
petrol stations (service stations), blasting areas etc.
3. Operation of any transmitting radio equipment may interfere with the functionality of inadequately
protected medical devices. Consult a physician or the manufacturer of the medical device if you have any
questions. Other electronic equipment may also be subject to interference.
CAUTIONS:
1. Servicing and alignment must be undertaken by qualified personnel only.
2. Ensure that all work is carried out at an anti-static workstation and that an anti-static wrist strap is worn.
3. Ensure that solder, wire or foreign matter do not enter in to mechanics of the radio, as damage may result.
4. Use only approved components as specified in the parts list.
5. Ensure all components, modems screws and insulators are correctly re-fitted after servicing and
alignment. Ensure all cables and wires are repositioned correctly.
6. It is recommended that the radio is powered down before disconnecting or switching off the radio's battery
or other input power supply. This method ensures the integrity of the file system. Make sure that the
power is really switched off (the powering down takes about 3 seconds after which the Power On LED
goes off).