EN
3.2 Product overview
1.
Cistern
- A place to store water for evaporation and air
cleaning.
2.
Disk
- The water in the cistern is pumped up and a
water film is formed on the surface with the water
being evaporated and the minute dirt being eliminated.
3.
Body (Main Frame)
- The fan and motor that control
the air flow is located here and clean air is supplied
through the exit duct in the left and right side.
4.
Operating panel
- It contains power button and
operation mode selection button. Also, it contains the
window which shows the operational status.
5.
Disinfectant device (BSS: Bio Silver Stone)
- Placed
in the floor of the cistern, it prevents and
contamination.
※Although the life cycle of the disinfectant may vary,
it should accommodate an operation period of 24 hours
a day for about 12 month. (For repurchase of the part,
please consult the customer service center.)
6.
Power cord
- Supplies Electricity to the Product.
7.
Upper cover
- The upper side is dried and the
contaminated air is taken in.
8.
Water level gauge
- It is possible to see the water level
from outside.
9.
Pre-filter
- It eliminates the dust of intake air first.
1. Water sensor -
Caution: Please wipe the sensor every
week. Water level may not be detected if
it is contamined.
2. Water level
It is marked on each side of inner part of
the water tank. Fill water not to exceed the
line.
3.
Disinfectant device (fixed part)
- It is located inside of the tank at the bottom right.
4.
Disc fixing part
- Fix it properly on the front and back side of the disc.
1.
Cap –
The disk is easily separated if you
turn it by using a coin in case of disk
washing.
2.
Warning:
The side with sticker attached
is the front. The product will not operate if
the front and back of the tank are changed.
3.3 Operation preparation
Page 8 of 17
